This is an old revision of the document!
Check parameters on the screen
Monitoring screen can not be operated, it is a display only. It shows the basic information of the PCS dynamically.
CODE. | ALARM |
---|---|
0 | AC overvoltage |
1 | AC undervolatge |
2 | AC overfrequency |
3 | AC underfrequency |
4 | Grid volatge imbalance |
5 | AC phase reversed |
6 | Inverter island protection |
7 | Grid-connected & off-grid switch error |
8 | Ground fault |
9 | Grid Phase lock fault |
A | Internal ambient over-temperature |
B | Grid detection timeout |
10 | Emergency power off |
11 | Monitoring parameter setting failure |
12 | DSP version failure |
13 | CPLD version failure |
14 | Hardware version failure |
15 | CAN communication failure |
16 | Auxiliary power failure |
17 | Fan failure |
18 | Bus voltage overvoltage |
19 | Bus voltage undervoltage |
1A | Bus voltage imbalance |
1C | AC relay short circuit |
1D | Output voltage abnormal |
1E | Output current imbalance |
1F | Radiator over temperature |
20 | Output overload timeout |
21 | Grid overvolatge sustained |
22 | AC soft start failed |
23 | Inverter start failed |
24 | AC relay open circuit |
25 | U2 communication fail |
26 | DC compnent of AC excess |
27 | Master-slave sampling abnormal |
28 | EE Read error 1 |
29 | EE Read error 2 |
2A | EE Read error 3 |
2B | Inverter overload |
2C | DC parameter contradictory |
38 | DC overvolatge |
39 | DC undervolatge |
3A | DC ground fault |
3B | BMS failure |
3C | BMS connection timeout |
3D | EMS connection timeout |
40 | DC soft start failure |
41 | DC relay short circuit |
42 | DC relay open circuit |
43 | DC power overload timeout |
44 | Bus soft start failure |
45 | DC quick check overcurrent |
48 | DC current overcurrent |
90 | parameter setting error |
91 | low energy in the off-grid state |
92 | Neutral line not connected |
93 | High bus volatge in standby mode |
95 | Frequency change rate excess |
96 | Rapid change in grid phase angle |