manual:pws2-30k:manual-operation-ex

This is an old revision of the document!


Monitoring screen can not be operated, it is a display only. It shows the basic information of the PCS dynamically.






CODE. ALARM
0 AC overvoltage
1 AC undervolatge
2 AC overfrequency
3 AC underfrequency
4 Grid volatge imbalance
5 AC phase reversed
6 Inverter island protection
7 Grid-connected & off-grid switch error
8 Ground fault
9 Grid Phase lock fault
A Internal ambient over-temperature
B Grid detection timeout
10 Emergency power off
11 Monitoring parameter setting failure
12 DSP version failure
13 CPLD version failure
14 Hardware version failure
15 CAN communication failure
16 Auxiliary power failure
17 Fan failure
18 Bus voltage overvoltage
19 Bus voltage undervoltage
1A Bus voltage imbalance
1C AC relay short circuit
1D Output voltage abnormal
1E Output current imbalance
1F Radiator over temperature
20 Output overload timeout
21 Grid overvolatge sustained
22 AC soft start failed
23 Inverter start failed
24 AC relay open circuit
25 U2 communication fail
26 DC compnent of AC excess
27 Master-slave sampling abnormal
28 EE Read error 1
29 EE Read error 2
2A EE Read error 3
2B Inverter overload
2C DC parameter contradictory
38 DC overvolatge
39 DC undervolatge
3A DC ground fault
3B BMS failure
3C BMS connection timeout
3D EMS connection timeout
40 DC soft start failure
41 DC relay short circuit
42 DC relay open circuit
43 DC power overload timeout
44 Bus soft start failure
45 DC quick check overcurrent
48 DC current overcurrent
90 parameter setting error
91 low energy in the off-grid state
92 Neutral line not connected
93 High bus volatge in standby mode
95 Frequency change rate excess
96 Rapid change in grid phase angle
  • manual/pws2-30k/manual-operation-ex.1592820620.txt.gz
  • Last modified: 2020/09/16 22:08
  • (external edit)