====== First time start ======

===== PWS1 series, grid-tied =====
  - Make sure all settings about battery are properly set.You must know the operating password.
  - On page **ctrl mode**, make sure it’s set to **Local Manual**
  - On page **settings-Sys**, make sure it’s set to **on-grid**(or  it can be **on** below **clear faults** in some legacy version)
  - On page** settings-AC**, you can set the **Power configuration**, fill it with your target power, the unit is kW. A **minus** number is discharging, while a **positive** number is charging.
  - On page **On/Off**, press **Sys ON**


===== PWS2-30K, grid-tied =====
  - Make sure all settings about battery are properly set. You must know the operating password.
  - On page **settings**, if you see **ctrl mode: remote**, change it to “local”
  - Back to the main menu.
  - On page **controls**, toggle to the second page, make sure it’s set to **ON-GRID**
  - On page **controls**, toggle to the third page, set the **Active power** to your target power, the unit is kW. **Minus value** indicates charging, **positive value** indicates discharging.
  - On page **controls**, toggle to the first page, press **ON**.
  - You can regulate the target power when the PWS2-30K is **ON**

===== PWG2 series, PV+ Storage =====
to be filled