Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
manual:pws2-30k:manual_operation [2020/03/12 02:01] hedy [Hardware parameters] |
manual:pws2-30k:manual_operation [2020/09/16 22:16] (current) |
||
|---|---|---|---|
| Line 112: | Line 112: | ||
| {{: | {{: | ||
| + | <WRAP center round tip 60%> | ||
| If the inverter is restarted or shut down due to power failure, the warning will still exist. After being powered on, the end time of warning will be expressed as “--/ | If the inverter is restarted or shut down due to power failure, the warning will still exist. After being powered on, the end time of warning will be expressed as “--/ | ||
| + | </ | ||
| Click **Logs** to enter the operation logs interface. This interface includes three columns: “number”, | Click **Logs** to enter the operation logs interface. This interface includes three columns: “number”, | ||
| Line 138: | Line 140: | ||
| + | <WRAP center round important 60%> | ||
| When the dispatched apparent power exceeds 30kVA, the output of active power will be restricted by reactive power, and the system will give priority to reactive output. | When the dispatched apparent power exceeds 30kVA, the output of active power will be restricted by reactive power, and the system will give priority to reactive output. | ||
| + | </ | ||
| <WRAP center round important 60%> | <WRAP center round important 60%> | ||