Differences

This shows you the differences between two versions of the page.

--- manual:pws2-30k:manual_operation [2019/01/24 04:01]
admin [HMI parameters]
+++ manual:pws2-30k:manual_operation [2020/09/16 22:16] (current)
@@ Line 10: / Line 10: @@
     CB---CBA[AC]
     CB---CBB[Battery]
-    CB---CBC[Grapgh]
+    CB---CBC[Graph]
     C---CC[status]
     CC---CCA[Warnings]
@@ Line 112: / Line 112: @@
 {{:manual:pws2-30k:image159_status_historical.jpg|}}
+<WRAP center round tip 60%>
 If the inverter is restarted or shut down due to power failure, the warning will still exist. After being powered on, the end time of warning will be expressed as “--/--/--”.
+</WRAP>
 Click **Logs** to enter the operation logs interface. This interface includes three columns: “number”, “message” and “Time before-after”. Click **<** and **>** under the interface to turn page up or down, click {{:manual:pws2-30k:image151_return.png|}} to return the main menu .
@@ Line 138: / Line 140: @@
+<WRAP center round important 60%>
 When the dispatched apparent power exceeds 30kVA, the output of active power will be restricted by reactive power, and the system will give priority to reactive output.
+</WRAP>
 <WRAP center round important 60%>
@@ Line 229: / Line 233: @@
 Click **Hardware** to enter hardware parameter setting, and click {{:manual:pws2-30k:image151_return.png|}} to return the main menu. This interface includes output voltage grade, output frequency grade, output voltage system, and module power rating.
 <WRAP center round warning 60%>
- WARNING	Users can review hardware information in this interface, but they cannot set the parameters. Any loss arising from customers’ modifying the parameters in this interface will be undertaken by customers.
+ WARNING
+ Users can review hardware information in this interface, but they cannot set the parameters. Any loss arising from customers’ modifying the parameters in this interface will be undertaken by customers.
 </WRAP>