Differences

This shows you the differences between two versions of the page.

--- manual:pws2-30k:electrical_connection [2019/01/03 03:53]
admin
+++ manual:pws2-30k:electrical_connection [2022/03/21 03:23] (current)
hedy [Bottom view]
@@ Line 2: / Line 2: @@
 PWS2-30K-NA electrical wiring should strictly following the following requirements. Please read the following carefully.
 <WRAP center round danger 60%>
- **DANGER**\\	Before electrical connection, please ensure that all switches of energy storage system are in “OFF” state. Otherwise, the high voltage of the inverter might cause an electric shock risk.
+ **DANGER**\\	Before electrical connection, please ensure that all switches of energy storage system are in “OFF” . Otherwise, the high voltage of the inverter might cause an electric shock risk.
 </WRAP>
@@ Line 16: / Line 16: @@
 ===== Bottom view=====
-{{:manual:pws2-30k:image133_bottom_view.jpg|}}
+{{:manual:pws2-30k:微信图片_20220321142840.png?600|}}
 ^No.	^Description^
 |1	|DC waterproof tube +	|
@@ Line 22: / Line 22: @@
 |3	|Ethernet waterproof terminal	|
 |4	|RS-485 waterproof terminal	|
-|5	|CAN waterproof terminal|
+|5	|R-EPO waterproof terminal|
 |6	|AC waterproof tube|
 |7	|AC disconnect|
@@ Line 32: / Line 32: @@
 {{:manual:pws2-30k:image134_remove_bottom_cover.png|}}
-===== Electrical terminals =====
+===== Power terminals =====
-The terminals of PWS2-30K is shown in the image below.
+The power terminals of PWS2-30K is shown in the image below.
 The cable colors, grounding, wiring should consist to the local electrical code.
@@ Line 40: / Line 40: @@
 The recommended cable size:
-  * Line: AWG 3
+  * Line: AWG 8
-  * Neutral: AWG 3
+  * Neutral: AWG 8
-  * PE: AWG 10
+  * PE: AWG 8
+  * DC: AWG 4 (better consult your battery manufacturer)
 <WRAP center round tip 60%>
-In some contries, such as United States, cables shall always be enclosed by conduits. In this case, the water proof caps should be removed.
+In some contries, such as United States, cables shall always be enclosed by conduits. In this case, the waterproof caps should be removed.
 </WRAP>
+=====  Bottom cover restore =====
+After power cables installed properly, the bottom cover should be reinstalled.