Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
manual:module-based:module-based_models_firmware_updating_instruction [2019/04/17 21:29] admin [Before updating] |
manual:module-based:module-based_models_firmware_updating_instruction [2020/09/16 22:16] (current) |
||
|---|---|---|---|
| Line 28: | Line 28: | ||
| ===== Before updating ===== | ===== Before updating ===== | ||
| <WRAP center round important 60%> | <WRAP center round important 60%> | ||
| - | Make sure the inverter is not running. | + | Make sure the inverter is **NOT** |
| </ | </ | ||
| Line 118: | Line 118: | ||
| - Check on #11 | - Check on #11 | ||
| - Click **Import**, Select U2_V[version].hex | - Click **Import**, Select U2_V[version].hex | ||
| + | |||
| + | ===== After Updating ===== | ||
| + | <WRAP center round important 80%> | ||
| + | Before leaving the site, DO remember to set the HMI to **Remote Control mode** if it was not in this mode! | ||
| + | </ | ||