Differences

This shows you the differences between two versions of the page.

--- manual:module-based:module-based_models_firmware_updating_instruction [2019/04/17 21:25]
admin [Legacy content before HMI V1330]
+++ manual:module-based:module-based_models_firmware_updating_instruction [2020/09/16 22:16] (current)
@@ Line 27: / Line 27: @@
 ===== Before updating =====
+<WRAP center round important 60%>
+Make sure the inverter is **NOT** running.
+</WRAP>
 <WRAP center round tip 60%>
 Updating priority sequence, unless informed by us:
@@ Line 32: / Line 36: @@
   - AC modules,
   - U2.
-</WRAP>
-<WRAP center round warning 60%>
-Make sure the inverter is not running.
 </WRAP>
@@ Line 89: / Line 89: @@
 Open the front door, plug the USB disk to the USB port of the HMI
-<WRAP center round warning 60%>
+<WRAP center round important 60%>
 Make sure that the HMI firmware: monitor.tar.gz, is **NOT** in the USB disk at this moment
 </WRAP>
 {{:manual:image004_usb_slot_back_of_hmi.jpg|}}
@@ Line 100: / Line 103: @@
-  - Enter the Upgrade page in Settings.
+  - Enter the **Upgrade** page in Settings.
   - Select Type as **DCAC**, and **Module**
   - Check all the modules that need to be updated
@@ Line 112: / Line 115: @@
 To UPDATE U2 Firmware, just repeat the procedures above, the differences are:
-  - Select Type as U2
+  - Select **Type** as U2
   - Check on #11
-  - Click Import, Select U2_V[version].hex
+  - Click **Import**, Select U2_V[version].hex
+===== After Updating =====
+<WRAP center round important 80%>
+Before leaving the site, DO remember to set the HMI to **Remote Control mode** if it was not in this mode!
+</WRAP>