Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
how_to:first_time_start [2019/01/01 22:18] admin |
how_to:first_time_start [2020/09/16 21:42] (current) |
||
|---|---|---|---|
| Line 3: | Line 3: | ||
| ===== PWS1 series, grid-tied ===== | ===== PWS1 series, grid-tied ===== | ||
| - Make sure all settings about battery are properly set.You must know the operating password. | - Make sure all settings about battery are properly set.You must know the operating password. | ||
| - | - On page “ctrl mode”, make sure it’s set to “Local Manual” | + | - On page **ctrl mode**, make sure it’s set to **Local Manual** |
| - | - On page “settings-Sys”, make sure it’s set to “on-grid”(or it can be “on” below “clear faults” in some old version) | + | - On page **settings-Sys**, make sure it’s set to **on-grid**(or it can be **on** below **clear faults** in some legacy |
| - | - On page “settings-AC”, you can set the “Power configuration”, fill it with your target power, the unit is kW. A minus number is discharging, | + | - On page** settings-AC**, you can set the **Power configuration**, fill it with your target power, the unit is kW. A **minus** number is discharging, |
| - | - On page “On/Off”, press “Sys ON” | + | - On page **On/Off**, press **Sys ON** |
| ===== PWS2-30K, grid-tied ===== | ===== PWS2-30K, grid-tied ===== | ||
| - Make sure all settings about battery are properly set. You must know the operating password. | - Make sure all settings about battery are properly set. You must know the operating password. | ||
| - | - On page “settings”, if you see “Ctrl | + | - On page **settings**, if you see **ctrl |
| - | - On page “controls”, toggle to the second page, make sure it’s set to “ON-GRID” | + | - Back to the main menu. |
| - | - On page “controls”, toggle to the third page, set the “Active power” to your target power, the unit is kW. **Minus value** indicates charging, positive value indicates discharging. | + | - On page **controls**, toggle to the second page, make sure it’s set to **ON-GRID** |
| - | - On page “controls”, toggle to the first page, press “ON”. | + | - On page **controls**, toggle to the third page, set the **Active power** to your target power, the unit is kW. **Minus value** indicates charging, |
| + | - On page **controls**, toggle to the first page, press **ON**. | ||
| + | - You can regulate the target power when the PWS2-30K is **ON** | ||
| ===== PWG2 series, PV+ Storage ===== | ===== PWG2 series, PV+ Storage ===== | ||
| to be filled | to be filled | ||