Differences

This shows you the differences between two versions of the page.

--- how_to:first_time_start [2018/12/26 21:43]
garfield_li
+++ how_to:first_time_start [2020/09/16 21:42] (current)
@@ Line 2: / Line 2: @@
 ===== PWS1 series, grid-tied =====
-  - Make sure all settings about battery are properly set.
+  - Make sure all settings about battery are properly set.You must know the operating password.
-  - On page “ctrl mode”, make sure it’s set to “Local Manual”
+  - On page **ctrl mode**, make sure it’s set to **Local Manual**
-  - On page “settings-Sys”, make sure it’s set to “on-grid”(or  it can be “on” below “clear faults” in some old version)
+  - On page **settings-Sys**, make sure it’s set to **on-grid**(or  it can be **on** below **clear faults** in some legacy version)
-  - On page “settings-AC”, you can set the “Power configuration”, fill it with your target power, the unit is kW. A minus number is discharging, while a positive number is charging.
+  - On page** settings-AC**, you can set the **Power configuration**, fill it with your target power, the unit is kW. A **minus** number is discharging, while a **positive** number is charging.
-  - On page “On/Off”, press “Sys ON”
+  - On page **On/Off**, press **Sys ON**
 ===== PWS2-30K, grid-tied =====
-  - Make sure all settings about battery are properly set.
+  - Make sure all settings about battery are properly set. You must know the operating password.
-  - On page “settings”, if you see “Ctrl mode remote” change it to “local”
+  - On page **settings**, if you see **ctrl mode: remote**, change it to “local”
-  - On page “controls”, toggle to the second page, make sure it’s set to “ON-GRID”
+  - Back to the main menu.
-  - On page “controls”, toggle to the third page, set the “Active power” to your target power, the unit is kW. minus value indicates charging, positive value indicates discharging.
+  - On page **controls**, toggle to the second page, make sure it’s set to **ON-GRID**
-  - On page “controls”, toggle to the first page, press “ON”.
+  - On page **controls**, toggle to the third page, set the **Active power** to your target power, the unit is kW. **Minus value** indicates charging, **positive value** indicates discharging.
+  - On page **controls**, toggle to the first page, press **ON**.
+  - You can regulate the target power when the PWS2-30K is **ON**
-===== PWG2 series, PV+ Storage grid-tied =====
+===== PWG2 series, PV+ Storage =====
+to be filled